Adjustable door guide for sliding closet doors. Modeled after the worn out original I replaced in every room of my home.

To print:

I used PLA, which works fine, but PETG would be a bit stronger and more resilient. Supports are needed for the inner guide. Print one inner and two outer pieces.

To install:

• Remove the old guide • Remove the front (outer) door • Slide the back (inner) door to one side • Position the inner guide so the tall piece is just a little in front of the door, and the edge of the door is just past center of the guide • Screw the inner guide in place • Insert the outer guide under the back edge of the inner guide and position just a little behind the door. Screw in place • Hang the front (outer) door back in place • Insert the second outer guide under the front edge of the inner guide and position just a little in front of the door. Screw in place