Hook for standard pegboard 1" spacing, approximately 1/4" holes. I made this hexagonal for easy printing measuring 5.4mm across. First hook is 2" long and tilts upward at 10%. Will hold 12.5lbs printed in PLA with 3 perimeters 20% infill. When the hook is parallel the ground it's about to break.

No supports needed.

Will add different shapes/sizes as I need here in the shop, or upon request.

Added J hook and holder for Milwaukee ratcheting screwdriver.

Added 4" x 4" pencil cup, printed ok on my Prusa without supports in PLA. Needed a little post processing to hang well. With and without cutouts for material/cost savings.

Hook pictured beside steel hook for comparison.