This was created in place of ordering slant boards that tend to be rather expensive. With a 5-10 percent infill it will use less that 500g of filament(depending on your infill pattern). This equates to less than $10 a board if you are using most generic PLAs.

I printed this on a Qidi-tech Xmax-II with a bed size of 300mmx250mm (to fit a fill sheet of paper on the board you will NOT be able to use a smaller printer).

To attach any papers to this slant board I used an extra large binder clip.

Thanks for checking it out and happy printing!

-Mr. Charlton