Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
This is a 3d printable, working electric generator / dynamo with a built-in gearbox.
This generator is capable of producing ~12 volts and ~1.75 micro amps. (For comparison, this is about as productive an AA battery)
Contents:
hull part 1 hull part 2 hull part 3 hull part 4 hull part 5 gearbox hull 1 gearbox hull 2 gearbox hull 3 2 big gears 2 medium gears a crank gear a crank rotor (2 parts) rotor shaft (3 parts) small shafts (5 parts) bearing replacements (2) extra gear for higher gear ratio
What is needed:
3 coils (Max size ~ 46x32x42 mm (The holes for the coils are oddly shaped, so a slightly larger coil could fit if it would be shaped right))
12 neodymium magnets (Max size: 10x10x5 mm)
2 bearings (Outer diameter 21 mm, hole diameter 8 mm) Note: These can be replaced with the provided bearing replacements.
Some wire (a 55 cm long wire should be enough)
