A case for the Raspberry Pi optimized for the MakerBot Replicator 2 Desktop 3D Printer.

The MakerBot Design Team made special enclosure designs for three of the most popular kits from Adafruit, the leader in DIY electronics projects. The Raspberry Pi, TimeSquare, and MintyBoost kits are all available for a limited time in the MakerBot Store in NYC.

Assemble the kits and make your own enclosures on your MakerBot.

See the Rapberry Pi kit from Adafruit here: https://www.adafruit.com/products/998

Pop the Raspberry Pi into the inner case. Slide on the outer case, then slide on the clamp and add the light. Clamp may require a bit of glue at the bottom.

For best results, print in PLA with the following settings:

Inner and Outer Case Infill = 10 Layer Height = .2 Shells = 2

Clamp Infill = 10 Layer Height = .2 Shells = 2

Light Infill = 0 Layer Height = .2 Shells = 50