I did this remix because the monitor used in the original design was unavailable, the print was too big for my printer and I had a different desk mount.

Stuff I bought

Monitor used: WIMAXIT 11.6" Amazon Dimensions: 284mm x 182mm x 16mm (not 14mm as advertised!). The case is a piece of sheet metal folded over so you can expect measurements to be out slightly.

HOTAS mount used: Hikig mount for Logitech X56 Dimensions: 60mm wide and 90mm deep. 20mm wide extrusions.

Thrustmaster MFD Cougar

Measurements worth noting

• VESA 75 holes are 52mm from bottom edge to hole edge, and 102mm from side edge to hole edge.
• The monitor depth gap is 16mm

Screws needed:

4 x M3 16mm countersunk - for attaching the MFD to the mount 4 x M4 10mm cap head - for mounting to vesa plate 3 x M4 16mm countersunk - for joining the two halves 4 x M4 12mm countersunk - for mounting the underside base plate 7 x M4 8.1mm brass heated insert

Changes to the original design

• The main body prints in two halves which should help printing on smaller printers likes mine.
• Added risers along a slightly chamferred rail which take M3 screws to hold the MFDs in place. I tried to use the original thumbscrews because they were chunky and sturdy but in the end were just too big and jutted out from the sides.
• Changed the mounting mechanism to use the HOTAS mount clamp itself.
• Added channels so that the MFD cables can come out of a single side; so that I can use a cable tidy sleeve to collect all the cables together.

Printing

It's designed to be printed from the middle up. I figured that if joining two halves then it'd look better with verticals lines all going in the same direction.

The base I just print flat as it is. It's been scaled down just a tad to allow for a good tight fit.

I recommend using tree supports. I've added 45 degree angles wherever I could to eliminate supports but I still needed 2 in the end.

I printed in PLA with 15% infill at 0.2mm resolution.

Anything else?

It's my first 3D design/print so hope you enjoy it!