Please note that this 3D model is for non-commercial use only per the license information below. If you have questions about if your intended use is OK, check the FAQ on my website or send me an email.

This is a driving cone, but tiny for your model horses. Like the real thing, these are hollow. Unlike the real thing, the balls are attached, so you can't drop or lose them. You'll have to paint them after printing to get the two-color look shown here.

This cone is set to be 1:9 (Traditional) scale. You'll need to print at least two for your driving cones course.

I've only printed these on an SLA printer in resin, where they did not require any support. They would probably print fine in filament, and probably wouldn't need any support there either, but you will have to test for yourself.