This print is specifically designed for the basic WiFi board straight out of the box, omitting features such as the antenna and SD card slot.

This creation is a remix of magdong's Wi-Fi Dev Board Case (https://www.thingiverse.com/thing:5564906).

For secure assembly, utilize 4 x M3x12mm screws accompanied by 4 x M3 nuts.

This design also has a pin protector boot cover that can be found in the following locations:

• https://www.thingiverse.com/thing:6104552

• https://www.printables.com/model/606861

• https://github.com/CodyTolene/3D-Printing/tree/main/Flipper%20Zero%20-%20WiFi%20Dev%20Board%20Case%20Boot%20Cover My print settings:

• Hatchbox PLA

• 0.2mm layer height

• 0.4mm nozzle (line width)

• Enable retraction

• Wall count 3 (+ print thin walls enabled)

• Top/bottom layers: 4

• Infill density: 20%

• Infill pattern: Cubic

• Print temp 200 C

• Bed temp 60 C

• No supports needed

See more designs on my GitHub here: https://github.com/CodyTolene/3D-Printing