Story goes my family lives relatively far from the nearest gas station/ super mart. My dad would go out and buy roughly 4x bottles of Pepsi (1L) and 2x 2L of water bottles, with or with out bag shortages.

So I made this, and its been super helpful ever since. Print with handle facing up with supports (however you want otherwise). In these photos you'll notice there is tape on the handle as I messed up my support settings to be a bit 'aggressively' stuck to the handle, which broke a small chunk off said area. Taped it with no issues after 4 weeks of using it. Maybe you'll have better supports than I did!

File says version 3 as the white one had bad connections to the bottles, as for the black holder was fixed with no issues other than my support settings being excessive.