You're on 3DFinder
We search Thingiverse, MakerWorld, and Printables at once so you get the best of each.
Description
set parameters in scad and export all parts.
print:
1x ring lay flat, no support
1x handle vertically on tripod end, no support
2x couplers lay flat. should look like a bridge on one end. supports needed for tongue and slot
slide led strip into ring
solder wires
feed wires through handle and solder a connector
put a coupler on each side of ring where the wires come out
put handle end over couplers, pin in place via scrap filament.
thread lib from:
3
Likes
0
Downloads
4
Collections
License
Creative Commons - Public Domain Dedication
Like this model? Create a free account to save your favorites and come back to them later.
Create account