A keyboard case for the surface duo.

Requirements: Keyboard - https://www.adafruit.com/product/3601 (shop around, there's other places that sell this) 5x 6mm M1.6 screws M1.6 threaded inserts 4x 30mm M2 hex cap screws A Microsoft Surface Duo Small snips of clear/translucent filament to plug the holes for the keyboard status LEDs - you can leave them just open but I quite like the softer diffused look that a small piece of cleaning filament gives me. You can set it in place just by holding a lighter beneath it for a couple of seconds to let it melt in place.

I don't check thingiverse much, so if you need help with this project then I am most easily contacted on Discord @ Zoemaestra#0119