I wanted a platform to raise my laptop so I can put stuff below it.

I liked the design by ddude3548 because it was made for corners. I liked the design by unclerotten because it is adjustable with threaded feet.

I didn't find any combination of them so I did them myself from the ground up but keeping the inspiration from these 2.

With the foot fully threaded in there is a distance between the bottom of the platform and the desk of 12cm (or around there).

There are a few extra cm of thread on the inside.

I printed these in PETG to learn about it and it shows that they are an experiment.

I didn't really measure to well the platform and I cut it a bit still too big (another thing to learn from).

The leg also has 2 holes for screws in the board, they have 3mm diameter.

I'm pretty happy with how they look, but I should have cut the board differently.