This component allows you to mount a brass brush in the front right corner of the heating bed. The brass brush I used can be found on Amazon as a spark plug brush. #Wooden handle. Shorten this brush to a length of 44.5 mm and attach it to the part with a 2mm thick double sided tape.

Next, use another strip of the 2mm thick tape and attach it to the printer corner.

The last step is then just to stick the part to the print bed.

Look image:

G-code for Cura:

G28 ; home all axes M117 Purge extruder G92 E0 ; reset extruder G1 Z1.0 F3000 ; move z up little to prevent scratching of surface G1 X300 Y83 Z0.3 F5000.0 ; move to start-line position G1 X300 Y283.0 Z0.3 F1500.0 E15 ; draw 1st line G1 X294 Y283.0 Z0.3 F5000.0 ; move to side a little G1 X294 Y83 Z0.3 F1500.0 E30 ; draw 2nd line G1 X297 Y83 Z5 F3000.0 ; pull up in Z for prush position G1 X310 Y49 Z1 F3000.0 ;lower for prush hight G1 X310 Y4 Z1 F3000.0 ;drive throw brush in Y G1 X309 Y4 Z1 F3000.0 ;sidestep in X throw brush G1 X309 Y44 Z1 F3000.0 ;drive back in Y throw brush G1 X310 Y44 Z1 F3000.0 ;sidestep in x throw brush G1 X310 Y4 Z1 F3000.0 ;drive throw brush in Y G1 X309 Y4 Z1 F3000.0 ;sidestep in X throw brush G1 X309 Y44 Z1 F3000.0 ;drive back in Y throw brush G1 X310 Y44 Z1 F3000.0 ;sidestep in x throw brushG1 X305 Y4 Z5 F3000.0 ;drive throw brush in Y G1 X310 Y4 Z1 F3000.0 ;sidestep in X throw brush G1 X309 Y4 Z1 F3000.0 ;drive back in Y throw brush G1 X309 Y44 Z1 F3000.0 ;sidestep in x throw brush G1 X310 Y14 Z1 F3000.0 ;drive back in Y throw brush G1 X310 Y4 Z10 F3000.0 ;end position in brush in X and Y G1 X207 Y14 Z10 F3000.0 ;drive to middle position G1 X150 Y14 Z1 F3000.0 ;Drive to bedsurface height

G92 E0 ; reset extruder

Ps: I have converted my printer to the Waggster mod.