These planters were modeled to be printed in vase mode. If you print them as is you will waste a lot of filament!

If you want more than 1 perimeter, instead of using vase mode you can use 0% infill and 0 top layers, then just choose how many perimeters you want. It won’t technically print the same way as vase mode (a continuous line), but will still get the job done!

**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the right to sell commercially.

If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at https://www.patreon.com/thinair3D