These are trays for the Table Golf Association 1st edition KS box w/ options for the KS Promos, Driving Range Expansion, European Expansion, 25 Bonus Tile Box. There are a few alternative prints that you can choose from {therefore, don't print everything below}. The pictures show the Base + KS Promos + European + Driving Range Expansions [50 tiles]{no lid lift and can be stored vertically}. Alternatively, the trays could have held the Base + KS Promos + 25 Bonus Tile box [56 tiles].

However, if you want to try and get all 75 Tiles into the box there would be a theoretical lid lift of approx. 3/4 inch. I increased the height of the trays shown in the picture. I did not print these but figured I would give the option to you to take those risks if you want to go for it.

There are also two options for card storage depending on your preference, both trays are shown in the pictures {one sitting inside a tile tray in the lower left (helps hold tiles in place for vertical storage)}; the other option is in the top of the tray between the two tile trays {if sleeved the sleeve edge may be exposed by 1-2mm.

Things to Print:

Option 1: Base + KS Promo + Driving Range + Euro {No Box Lift}

• File: TGA Tile Tray (x4) {4 copies}{1 per corner}{3 base & Promos and 1 Euro Exp}
• File: TGA Tile Tray Center (x1) {1 Copy}{Middle Tray}{Holds 9 Driving Range Tiles}
• File: TGA Tray Ball & Die {1 Copy}
• File: TGA Lid Ball & Die {1 Copy}
• File: TGA Spinner Tray {1 Copy}
• File: TGA Trophy Tray (x1 or x2) [1 Copy to hold Trophy, and could print a 2nd for the other side but is not needed outside of aesthetics]
• CHOOSE OPTION A OR OPTION B
• File: TGA Card Tray Opt B {1 Copy} {stored on top of tiles in one tray}
• File: TGA Card Lid Opt B {1 Copy} Alternatively, could print File: TGA Card Tray Opt A {1 Copy} if you want to free up space for added tiles from the bonus tile box of future expansions.

||||||||||||||||||||||||||||||||||||

Option 2: Base + KS Promo + 25 Bonus Tile {No Box Lift}

• Same prints as Option 1

||||||||||||||||||||||||||||||||||||

Option 3: Base + KS Promo + Driving Range + Euro + 25 Bonus Tiles {est. 3/4 inch box lift}

• Alt TGA Tile Tray 16 (All)(x4) {4 Copies}
• Alt TGA Tile Tray Center (All)(x1) {1 Copy}
• TGA Card Tray Opt A {1 Copy}
• File: TGA Tray Ball & Die {1 Copy}
• File: TGA Lid Ball & Die {1 Copy}
• File: TGA Spinner Tray {1 Copy}
• File: TGA Trophy Tray (x1 or x2) {1 or 2 Copies}{the height on these was not increased from Option 1. If planning vertical storage the trophy may come loose, but if horizontal then it should not matter.

Printer: Ender 3 S1 Pro Cura Slicer Profile: CHEP Beta V5.0 Hyper Fast 0.32 Profile {Youtube Search: CHEP Free Cura Slicer V5.0} Nozzle: 0.4mm Layer Height: 0.32 mm Infill: 25% Supports: No