This is a basic insert for Woodcraft. Should help a bit with setup and table presence. You don't NEED to print the box spacers, but they will help keep things where they go in the box.

Also, while I have enough space in each player box for all starting resources, there is also plenty of room if you wish to keep all the dice with the dice, and the blueberries with the blueberries, etc.

There is a little bit of slop here and there of .5-1 mm. Also, there is one "big" gap where I didn't bother with a spacer at all -- this space can be seen to either side of the blueberry cards. This just aids a little in removing everything from the box. The yellow blueberry tray is only yellow because I ran out of brown PLA.

I don't have it completely sleeved yet, but it should work with sleeves -- specifically Sleeve Kings.

Otherwise, I think it's all pretty straightforward.

The number of each file to print is embedded at the end of the filename.