Frog Bong! This model isn't ready to print and use as a bong as is, but all that is required is to modify the "plug" to your liking to fit a downstem of your choice. The pipe file that is included requires some minor glassblowing and a thin downstem to work. It does look good though, and in general I'd recommend using this as an art piece instead of for consuming any "smoking herbs".

If you're gonna print it in full size I strongly recommend a >0.6mm nozzle, 0.3mm layer height, sparse organic supports on the bark at the back (if your slicer has support), and some loose-fitting painted on supports on the pipe plug.

for printing the pipe (this design is kinda scuffed in terms of being functional) I printed it in 2 halves, and then cut off the top of the pipe and the inside of the plug, plastic welded the 2 halves together, and then sanded it all. I was in a massive time crunch so the pipe design could really be a lot better. The frog plug should print pretty decent and fit in well though, or you could just print it without the hole (the stl is in the files, it just doesn't show up as a thumbnail)

Original STLs: https://www.thingiverse.com/thing:35595 https://www.thingiverse.com/thing:2853566