This unique HO scale (1/87th) LOG BUILDING is representing a building under construction. The logs are detailed both inside and out so if you want the project to look earlier than finished just stop your printer at what ever level of completion you would like.

Depending on your printer, some components may require some minimum minor trimming. I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of printed scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished.

If you would like me to design a custom model for you contact me at:

garylavart@yahoo.com.