Yeah, I know, angled scrapper is cool but it needs supports to print. I know, but… Its much more easy to use than the regular scrappers. Why you ask? Well, a couple of reasons: 1. Is more ergonomic, fits better in the hand and you can even press the scrapper with one finger while holding it, making it easier to get underneath those pesky prints; 2. When you finally are a bit under the print you can pivot the scrapper and make model pop from the bed with little effort (definition of effort might vary from person to person ;) ) So yeah…, I know supports, but I think its worth having then and then get a better concept ;) Also if you find it to be a bit small, you can scale it up a bit.

Printing Instructions: I suggest you using PTEG or similiar.

Material: PETG (or similar) Infill: 15% Supports: Yes Change filament during print: Only if you want Brim: Not needed Raft: No

All models are print ready oriented.