Hi everyone,

this is my version of a fully programmable Kryptex. The idea was not my own; all inspiration was from the following thing: https://www.thingiverse.com/thing:1412931

But I found some points that I wanted to improve and also I wanted to try out to design a more complex model with several parts like this.

This was motivation enough to create an own model based on the given parts with some improvements:

• tolerances are at 0.3mm in order to create enough room for rotating and everything
• the inner rings are designed in a way that any position is lined up with a specific letter
• the inner ring has no sharp edges which makes it easier to print
• the outer ring has all letters from A to Z and one additional free spot acting as a space to provide more flexibility
• because of the more letters the radius enlarged which also enlarged the volume inside of the whole Kryptex

No need to say that you need to print both the inner and outer ring 5 times.

You have to be careful by assembling this. Since the inner rings are quite free to move you might "reprogramm" your Kryptex unintentionally. But as soon as you have the lock in place everything is fine

I had a lot of fun designing this and therefore I wanted to share this with you.

Happy printing