This print is a STRUCTURAL MODEL HO (1/87th) SCALE RAILROAD BRIDGE is intended as a pedestrian cross over or doubled side by side as an automobile bridge. It is 58 feet length in scale.

I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished.

If you would like me to design a custom model for you contact me at:

garylavart@yahoo.com.

It is totally free but I will post it on Thingiverse for others to print and enjoy.