Remix of Wedge locking the door

• Redesigned to allow printing grips with TPU
• Base is now flat to augment friction (event if it bend a little)

Guide

• I recommend:
  • PETG for the body for better flexibility
  • TPU for grips
  • neoprene glue is good for TPU because this glue stay flexible
• The provided STLs should fit for gap in range 30mm - 40mm (35mm average)
• They can be used for other gaps with simple scaling. Example:
  • For a gap of 70mm (my case): scale = 70/35 = 2
  • This will print a wedge for range 60 mm - 80 mm

Source

• The source is a FreeCAD design (.FCStd) with parameters sheet in case scaling do not fit your needs.

Print Settings

• Printer brand: Prusa
• Printer: I3 MK3S
• Rafts: No
• Supports: No
• Resolution: 0.2 mm
• Infill: 20% for the wedge body, 100% for the TPU grips
• Filament material: PETG for wedge body, TPU for grips