This is a DIY electronic table dice. It measures about 8,5 x 8,5 x 2,5 cm. It's designed for 7 single LEDs and 4 push buttons and it is powered via a 9volt block battery. The dice runns on an ATtiny 84 or even 85.

The case is equipped with an M3 threaded insert for 3D printing, so you can open and close the lid as often as you like.

Visit my GitHub site for the source code of this project.

You like it? Then I would be very happy if you treat me to a coffee on ko-fi.com/pixeledi

Check out all my other stuff on: linktr.ee/pixeledi.

Have fun pixelEDI