Beaglecam tripod Bracket bracket https://www.3dprinteraccessories.shop/products/mintion-beagleprint-beagle-camera

Well, this is a mini tripod, which brings a lot of freedom, such as the distance from the camera to the printed model, the height, and the inclination angle. It basically gets rid of the vibration the machine might bring, and you can even modify the length of the telescopic pole to support higher heights.

The estimated total print time for the gcode files in the file is 8 hours and 57 minutes.

The triangle part refers to "Mini Tripods by walter". The original design is very elegant as a whole. I prefer its one-piece design, which is very simple to print.

Finally, share the problems encountered in printing. After I adjusted the unfolding angle, the printing encountered problems. The gap was too small, resulting in the lack of support, and then the printing of the active part failed, so I added the "tower" in the support of the slicing software. Setting (this is a function for small gaps that cannot be supported without support, using Cura).

Small suggestion: Stick EVA non-slip pad on the bottom, it works very well.

If you have any suggestions or other, you can contact me. Enjoy it.