Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Easter is near so I thought I would design some eggs. Hope these are not to late to print and have some fun with!
These can be printed in vase mode or normal mode with 0% infill. They are hollow which will save using some filament. Each egg has the x and y axis at 54 mm and z is 70 mm tall. I haven't printed all 9 designs, only the 5 pictured, but they all should print fine. The tops of the eggs didn't close well in vase mode, normal mode printed the best. I used a 5 mm brim but I suppose a raft will also work. The base of the egg has a small foot print. Enjoy....
Notes are below.
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta