Bogie for Super Chief coaches

Same mech inserts as the F7 mechanism.. Different screw hole position Use the F7 axle guide. to get bearings and bearing holders in position.

Update, 7th April 22. fixed and minor redesign of bogie.Bogie nut was too tight, hopefully fixed. Update, 25th April 22.. minor edit to bogie shell to accommodate wheel edge. (Bevel at inner end of shell end)

I have only checked the running height of models against the F7 in "TinkerCad", It may need washers or maybe the round bit on top of bogie trimming slightly. Will update when/if I get that far.

Update. Cut off top of bogie (v2) for easier printing, several washer thicknesses provided as spacers (3.7mm was the thickness cut off.)

As series of carriages this bogie.

Bogie is used for the following:

Dining Car: https://www.thingiverse.com/thing:5334363 Observation Car: https://www.thingiverse.com/thing:5333532 Passenger Car: https://www.thingiverse.com/thing:5334371 Baggage Car: https://www.thingiverse.com/thing:5334596 RPO Coach: https://www.thingiverse.com/thing:5334602 Sleeper 10 6: https://www.thingiverse.com/thing:5334604 Duplex Sleeper: https://www.thingiverse.com/thing:5334607 Mail Car: https://www.thingiverse.com/thing:5334635 Part Dome: https://www.thingiverse.com/thing:5334796 Superdome: https://www.thingiverse.com/thing:5334797