Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
I've had a blast designing this helicopter blade spinning assembly that deploys when your Motor ejection charge blasts. Using rubber bands to snap open the blades, they will spin and (hopefully) slow your rockets descent. I also make use of a small drogue chute (9" Estest) which is very undersized on its own for a rocket this heavy but along with the spinning rotor, i've recovered this rocket from launching multiple times. It uses a BT-70 body tube and can fit E and D sized motors (24mm). You will need some M3 screws (4 of them) at either 16 or 18mm along with 4 M3 nuts and the rest can be printed. i've attached a PDF with detailed instructions
Parachute: https://www.amazon.com/Estes-2268-9-Inch-Printed-Parachute/dp/B00TKBM50I M3 Screws: https://www.amazon.com/gp/product/B07VNDFYNQ Aluminum Tubing (Optional): https://www.amazon.com/uxcell-Seamless-Aluminum-Straight-Tubing/dp/B07WLN69T1 BT-70 Tube: https://www.apogeerockets.com/Building_Supplies/Body_Tubes/Low_Power_Tubes/56mm_x_18_Body_Tube_Estes_BT-70_size Kevlar Shock Cord: https://www.apogeerockets.com/Building_Supplies/Parachutes_Recovery_Equipment/Shock_Cord/Kevlar_Cord_100
Check out the video and if you decide to give this a shot, please share a make with me so i can enjoy it!
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta