Update (v2 files)

• Slightly increased the inner tolerance of the handle body
• Added a buffer to the side facing the build plate to provide more material for sanding off support nubs.
• Reduced the height of the lid (prevents the chisel holder from rolling when set down.

Chisel holder made to fit SAB scribing chisels. Designed to be printed with an SLA/resin printer, so the tolerances are pretty tight.

While not necessary, up to three round magnets (4mm diameter; ~1.5mm thick) can be added through a hole in the back of the chisel handle for a more secure hold. Use the end plug part to plug the hole (ideally with glue or resin).

Print orientation: all of the files are already set to the proper orientation, including the main body. I would recommend that you print at a 20-30 degree angle to help with drainage. Use platform supports, and ensure the tip of the main body (where the chisel is inserted) has extra supports.

Parts List: 1. Holder body 2. Screw cap 3. Rear end plug 4. Protective lid