Hex Key

Remixed from my original Hex Driver Bit Holder (Sept 08 2020).

Compact hex driver with magnet to hold hex bit. Nearly the same as the original but a bit smoother with a space to insert a 6 x 2 mm magnet (easily sourced on Amazon or Ebay). If you print this version without the magnet the hex bit will be loose (use the previous version for a push fit). Use the gcode to print directly - otherwise set up your slicer to pause at layer 48 (if using the settings below) and drop in the 6 x 2 mm magnet. Resume print.

SETTINGS: Orientation already aligned in the files with the open hex face upward Layer height: 0.2 mm Infill: 10% Brim: 4 mm Supports: None Material: PLA, PTEG, etc

Regards, Paul