Here is my 10" server project to store 2 Raspberrys with Repetier Server with 2x12 Prusas All panels are aligned with the front on the print bed.

1. Fan slot This panel is to keep the distance to the fan. Here 0.4mm is printed black, then a filament change to silver, again 0.4mm, then black again.
2. Free slot This panel is printed single and will be used multiple times in my 15U project. 3.Power This panel will be printed like Fan Slot again. 5mm LEDs
3. Raspberry I made the Raspberry Pies once on the left and once on the right. It's only for visual reasons. It only fits the Pi version 4. 4 red and 2 green LEDs are used to illuminate the logo. Between the panel and the silver part I put some greaseproof paper, which I colored red and green with felt-tip pens.
4. Cable bushing The panel is again printed face down. For optical reasons I glued a silver ring inside and outside. 6.TP-Link SG108E The cutout is 26mmx158mm
5. USB hubs Since the USB hubs are too big for one height unit, I combined them with the cable outlets. Here you have to print with support structures. The outlets are then smaller, so there are other rings here.