UPDATE: 25/10/19 Added SyncTopBumper1&2.stl These are needed for the LHS of the sync generator on the pieces with the holes in for the bumper.

UPDATE 9/10/18 Added top and bottom expanded assembly views.

UPDATE 2/12/17. This part was used in the Ghostbusters Station 6 fan film. Check it out on youtube at https://www.youtube.com/watch?v=RHMUsQqLmRg

UPDATE: 23/06/16 Added link to synch generator details

UPDATE: 17/2/15. Rotated synch gen bumper parts.

UPDATE: 9/2/15: Added Tube clamp, detail and segment to allow easier mount for proton thrower tube. Print one of each.

UPDATE 22/01/15: Added pre-holed parts (bumper1,2,3) to allow easy mount of bumper at:
http://www.thingiverse.com/thing:87161

If you like this, please take a picture and post a 'I Made One'. Thanks!

A full size, 3D printable version of the Ghostbusters' proton pack
synch generator.
Based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/Stefan_Otto%27s_Prop_Plans
Print 2 copies of SynchSegment.stl.
Print 1 copy of TubeSegment.stl, TubeDetail.stl and TubeClamp.stl
Print 1 each SynchGenBumper1,2,3
Print 4 copies of SynchSegmentTop.stl
Print 1 copy of SyncTopBumperLhs1.stl << Use SyncTopBumberLhs1 & 2 for the Print 1 copy of SyncTopBumperLhs2.stl << LHS SyncGenBumper parts. Bolt all none 'top' parts together with M4 bolts.
Bolt all 'top' parts together to form the circle base.
Bolt 'top' parts onto motherboard with holes set into part face.
Bolt and/or glue the top and none top parts together.
Add details from https://www.thingiverse.com/thing:556060