The BL-Touch is way too bright: this cover cuts the light right down and just leaves a clean vertical light bar.

UPDATE June 2025: Added a new version for Ender 3 v2 which is secured using the touch sensor's rear screw instead of a friction fit.

• Designed for the Ender 3 v2, but as it does fit other printers there are four additional versions. The "... EXIT" in the filename shows where the cable exits when the light faces the front. The new version with the screw retaining detail exclusive to the Ender 3 v2.
• Tool-less design slips on and is retained by two small internal bumps.
• Installs in-situ: nothing to unmount.
• Light and strong design.
• When correctly installed, the probe pokes out a couple of mm or two from the bottom when retracted.

Not remixed, but would like to acknowledge a few similar things:

• https://www.thingiverse.com/thing:4905040
• https://www.thingiverse.com/thing:4751635
• https://www.thingiverse.com/thing:5191034
• https://www.thingiverse.com/thing:4804147
• https://www.thingiverse.com/thing:3197149

PS: $5.00 says somebody at Antclabs accidentally reversed the red light's on/off setting and they've been stuck with it ever since ;-)

Check out more printer accessories from Department_Nine!