This is a 2" pod, 1.75" Diameter (50mm x 45mm Diameter). It can hold up to 80 milliliters of whatever you'd like to keep with you (skittles, mints, M&Ms, pixelbuds, tic tacs, LEDs, sawdust, candy corn, real corn kernels, breadcrumbs, 1/4-20" hex nuts, airpods, tap-its, coin batteries, smaller containers, SD cards/flash drives, and more quarks than you can count in your lifetime).

Layer Height: 0.2mm Line Width: 0.4mm Print Speed: 60mm/sec

The tolerances were set for these parameters so you may find the clearances to be tighter or looser if you deviate too far from these settings. Your print may also be affected by the calibration settings of your machine.

The .f3d files are available upon request. Happy printing!