(I hope I didn't forget to upload a file)

This is a remix of a remix of a remix....

A remix from https://www.thingiverse.com/thing:5168552 from https://www.thingiverse.com/MyStoopidStuff

Which is a remix from my https://www.thingiverse.com/thing:4854682/remixes

which again was a remix from https://www.thingiverse.com/thing:4833955

I have changed the figure of the body and top part, added a kind of knob (thanks MyStoopidStuff for this Idea) to both parts, reduced the diameter of the screw thread and modified the form of the screw a little so that it fits better.

Top and bottom parts are printed without support. For the body I select the suport as tree, that creates cleaner internal surfaces and it's easier to remove.

26.03.2022:

for clearance (for johntron):

• V2 means, this is the new design of the top and bottom part with the "knob". They differ form from the earlier design here https://www.thingiverse.com/thing:4854682/remixes
• Standard size: The body measures 52mm square, 25mm high
• Large size: The body measures 60mm square, 30mm high
• Size 150: The body measures 80mm square, 25mm high.
• Size 200: The body measures 105mm square, 25mm high

The sizes 150 or 200 mean that a cable with normal thicknes and a length of 150 or 200 mm should fit in there. But this is only approximate and depends on the cable diameter and stiffness.