Here is a deck box for Magic: the Gathering, or Pokemon or Yu-gi-yo! This box holds a single sleeved Commander deck (100 cards), with a second compartment for tokens, counters or your sideboard! The second compartment does not hold a spin-down dice, but it will hold up to a standard DnD d20. The lid will open if its turned upside down, but it has a little grip and a little snap when it shuts.

If your filament is easy to scratch up or is tough to remove supports on, I think it would probably be okay to print without supports, but that judgement is up to you.

I may put out a newer version of this box, perhaps involving magnets, a clasp to hold the lid down, or a decal, but this is the jist of what I wanted to make.

Printed in PLA with .16 layer height and 100% infill