A little attachment that can be put on the handle of the Work Sharp Precision Adjust abrasives. It allows to attach a angle cube or similar tool to be magnetically attached for hassle free and hands free angle adjustments.

Attention: After printing check that it fits perfectly. there should only be some play to slide up/down ca 0.5mm as this short wiggle helps to seat it flush against the handle.

I used M4 washers with an outside diameter of 12mm and glued them in with superglue. Make sure they don't protrude above the surface. From what I could find online a #8 SAE washer should be about the same size.

For a smooth top layer I enabled the ironing function of my slicer but it should be fine without that or a quick (slight!) sanding.