I hope that these files will help people enjoy the game more! If you have any remarks, questions or sugestions please let me know.

This is my version of the Euthia insert. Everything sorts well into the box and is easy to take out and to use on the table. Most models are a bit bigger then needed to support the upcoming expansions without a reprint.

Marketplace tower is in the screenshot was too long. final version has been modified to 15cm in height. Though I haven't printed that one again. Model is the same as the treasure tiles which is shown in the photo's. Just height changed. The towers were printed at resolution of .16 instead of .24 for the rest.

treasure tile tower is printed twice, once for the treasures and once for the natural resources.

There are two versions for the map tiles. Depending on your own preference:

1. by level (all boxes are 50mm in height)
2. by type (fixed, encounter and scenario are 40mm high, other is 82mm in height.

All files in here are 1.0 files and have been printed myself. unless stated otherwise.

There's been plenty of hours and prototype printing into this project and the other files to complete will be here in a short while. I share this content to support the open source 3D printing community. Even though any small donation would be appreciated. Even if only a dollar to support making the prototypes.

29/12/2021 token holder added for Dice, Gaar, Dwurt, money and other tokens of the game

3/1/2022 added: Card tray for: Control, Silver and Gold cards Gems and essences Monsters lvl 1-3 Elites 1-3 Bounty 1-3 Farruga, Mirrezil and Rampage

The trays in the picture are prototypes. The 1.0 versions are corrected: Gems and Essences letter don't show through, Farruga, etc have it's dedicated tray. Small misprint on the Bounty tray (some warping). I did not reprint those from an environment point of view.

Currently in development Encounter tray