I've designed this to be a simple, smaller-profile handstop with some added textures for looks.

This is designed around MLOK and utilizes the following hardware:

• M4 Bolt (25 mm)
• M4 T-Nut

I print with the rectangular slot guides down plus supports which I find to be the best orientation for aesthetics/ease of printing.

For the "SurfaceFlatten" file, you may print it out as a cutting guide for any Talon/skateboard grip sheets to affix to a non-textured grip. Please see photos for example of applied Talon rubber grip. Requires some heating to apply. Air bubbles may be difficult to remove.

If you have any suggestions for improvement, I'm all ears. Thanks!

Approximate dimensions:

LWH: 35.75 mm x 19.50mm x 42.00 mm (1.41" x 0.77" x 1.65")