This an adjustable depth monitor/PC stand based on manteniendo's design https://www.thingiverse.com/thing:4363691

This is a great design, as the support is in two pieces, I can print it with my Ender 3 to support a larger stand than the printer.

I have shortened the support width by 80mm, will support timber width from 232 - 276mm.

I found the tolerance on the male support insert may be too thick, I used a knife to trim off a little to fit easier.

TO PRINT TIGHTING SCREW AND BUSHES Layer height: 0.2 Infill: 100% Supports: No

TO PRINT SUPPORTS MALE AND FEMALE Layer height: 0.28 Infill: 20% Supports: No