Hello everyone,

This is my own design of a V8 engine as I designed it on a CAD software. It consists of the block, the oil pan, the pistons, the connecting rods (two halves), the pin and the crankshaft. Once assembled it is fully working as you will see in the video.

I recently printed and assembled the whole thing. You can watch, and I fully recommend you to do so, the full process here: https://www.youtube.com/playlist?list=PLephZuPisc1RY15smTGaCdNZyY66_k4nD

Notes:

Con Rod - print 8x, supports on

Oil Pan - print at 25% scale, no supports

Crankshaft - print at 25% scale, supports on

Block - print at 25% scale, no supports

Piston - print at 25% scale, 8x, no supports

Easel - print at 25% scale, 8x, no supports

Pin, print 8x, no supports

Again, I fully recommend you to watch every single video to see my mistakes so you don't repeat them.

Tolerances are tight, some bit of sanding would be advantageous.

No additional hardware needed