this is a model of the phantom from the project 863 YouTube channel. You can print the whole thing at once but I would suggested printing the head separately. For the led version I printed the body and the separately with 2mm walls and no infill. Then I drilled a small hole on the foot and the top of the body for the wire. I drilled a hole in the bottom of the head and put an led inside then I connected the wires to the led and glued the head on. The base has a cutout in the back for a battery pack(do not glue the battery pack in place you need to remove it to replace batteries). There is a space in the base to run the wire into the bottom of the foot. If you are printing this at 100% scale some of the parts will be too small (863 logo, 863 logo base, vial). For the vial I extrude some polysmooth clear filament through my printers nozzle and cut it to length.