This is a remix of the Nintendo Switch Mount for pro controller by NamelessParanoia which incorporates a movable arm from the Modular Mounting System.

Instructions

I printed this in 0.2 mm layer height with 20% infill and supports (required) at 15% density.

1. In any order print these 4 files

• Arm Switch Holder (remix on Modular Mounting System)
• Holder.V2 (Unchanged from Nintendo Switch Mount for pro controller)
• Switch Holder Mount (remix on Nintendo Switch Mount for pro controller)
• Pro Controller Mount (remix on Nintendo Switch Mount for pro controller) (Mount_Connector_Flat does not need to be printed, this is here to make remixing easier)

2. Assemble Prints

• Remove all support material
  • I had luck with using a box cutter to remove support material from within the hinges then I used a marker tool like this to remove support material from the holes.
• Clip Holder.V2 into the Switch Holder Mount
• Insert arm into both hinges and insert the bolt, then tighten wing nut and assembly is complete.

Total print time should be around 5-10 hours, I didn't keep close track on how much time was spent, but I was able to complete this in an afternoon.

To connect the arm hinges you will need an M5 bolt (in pictures I used a 35mm bolt because that is what I had access to, a shorter one can be used if desired) and an M5 wing nut.

(optional) In the Modular Mounting System there are files for a printed bolt and nut. I have not tried these out as I had a bolt available, but if you try that leave a comment here letting me know if that worked!

Functionality

This currently only will fit with the Nintendo Switch Pro Controller (and any other 3rd party controllers that are the same size, I have not tested any)

Future Plans

I plan to update this post eventually to support more controllers (specifically the 8Bitdo SN30 Pro + and PowerA Wireless Gamecube Controller since those are the ones I use most often). I have included a file (Mount Connector Flat) here which is just a single flat Male connector from the Modular Mounting System. This can be added to a mount that fits another controller if you are interested in adding support for a controller yourself in another remix.

Changes In this Remix

• Added Hinged arm to provide more flexibility in switch angle while playing
• Removed sharp corner near D-Pad

Updates

• 9/22/2021: Made cut out for right analog stick on the Pro_Controller_Mount larger to allow stick to fully go to right without hitting mount.