Designed this yarn holder for my mom. Thought it might be usefull for other people so putting it here!

It is made to fit with a 808 bearing (skateboard bearing)

Printing:

I would suggest 15-20% infill at .2 layer height since there is a threaded part. 4 perimeters!

Parts needed:

• 808 bearing
• Base.stl

-Corps 1 -Corps 2

-Insert -Socle

The _v extension (ex.: Corps2_V) means that the part is designed with a Voronoi pattern. It looks cool, but takes a little more time to print (about 30-40min)

All parts fit snuggly together. You probably will need a plier to screw the insert in the main spinning part. Be careful, grab the little step and not the axle itself, to prevent distortion to the axle.