Protect your microphone signal from part of the echo of the room.

Print : 2xSidePanel 1xFrontPanel 1xMicrophoneHolder

Buy : 4 M4 10mm screw 4 M4 self-locking nuts 3 25x25cm soundproof panels

I printed the panels on their round side, with support enabled.

Assemble the panels with 10mm M4 screws and self-locking nuts.

The holes in the MicrophoneHolder piece are designed to have standard 5/8" threads. If you don't have a proper 5/8" tap, you can do as I did, and use your microphone stand as a tap to create the threads. If using PLA, the plastic is soft enough for this to work.

For the sound proof material, I used 25x25cm panels from Aliexpress : http://a.aliexpress.com/_vKiKO8 Cut 173x157mm rectangles in the panels and it will fit right into the panels, no need to glue them. (You need to make a groove in the sound proof material for the center panel).