I have made a 2 versions of the Dual Sense controller dock:

Main Body

Version 1 - (With cut out) This version allows for the charging cable to be run into the dock and connected when needed to charge.

Version 2 - (Without cut out) This is the same design as V1 but isn’t designed as a charging station but only as a dock for the controllers.

Side Panels Both side panels are designed to fit both V1 and V2. Can be glued into place after printing and painting. Note- they are a left and right design.

Infill Main Body was printed a 15% and sides were printed at 20%

Note: Controllers can fit both ways. (It was a happy accident)

Pls let me know how u guys go