More details in this video: https://youtu.be/iJEq-vBG1Ws

I had a bit of an issue with bed adhesion so I made two versions, one with a brim and one without. I printed these with a .8mm nozzle and it took about 11 hours per leg.

The one with the brim is also designed to be printed at a slight 25-degree rotation flat on the bed. This allows each layer to be at its maximum length across the leg which in theory would result in a stronger print. I definitely recommend this if you're going to put heavy weight on this table like... I did in the video.

CR-30 PLA 15% infill 2.4mm wall thickness