The original design was too thick and i want a minimal design, so i remixed and here there are the modification:

-The thickness of the bracket was reduced from 20mm to 10mm -Added a version of the bracket for 200x200 buildplate (Bracket_10mm_short) -Backplate was edited to adapt to the new bracket,some space has been left between the lifter and the BackPlate to increase the tension- -The Backplate hole before was 3.21mm now they are 2.88 so the M3 screw can fit it. -There are two version of Lifter

Lifter:is the original lifter and can fit all gpu Lifter_without_tooth: is the lifter edited for the GPU which have little space between the fan and the edge of the GPU.

TIPS: You can use 2 lifter, one in the center of the GPU and one at the edge to better distribute the weight.

REQUIRED HARDWARE:

For one lifter: -5 M3x25 screw -5 M3 washer -5 M3 nuts

For two lifter -7 M3x25 screw -7 M3 washer -7 M3 nuts -Another print of lifter and backplate