This is intended as a token for Magic the Gathering to keep track of your treasures. Although I imagine it can have other uses as well. Perhaps as a fancy life dice holder. The diameter of the base is 7cm, slightly wider than the standard mtg token width.

There are different configurations based on the dice you want to use and if you want the sword included or separate.

There is a D20 configuration, sized for spindowns that come in the pre-release kits and for the average D20.There are 12mm D6 and 16mm D6 configurations. Finally there is a configuration with no dice holder included.

If you wish, you can print the sword separatly to position how you want, have it print a bit easier without the internal supports the sword would need, or to replace a broken sword if that may happen. Just print a 'no sowrd' version of the base and the seperate sword file.

Hope you like it!

Thingiverse remix linker is borked, so here are the sources I used: https://www.thingiverse.com/thing:2463894 https://www.thingiverse.com/thing:2010492 https://www.thingiverse.com/thing:2242201 https://www.thingiverse.com/thing:783285 https://www.thingiverse.com/thing:764146