Tronxy's data sheet for the X5SA states Layer Resolution 0.1mm-0.3mm

If you want to check what you can actually get when using a smaller layer height in your slicer then some test objects may be helpful.

I designed these two objects for testing different layer resolutions:

• Inclined Planes
• Ball Cap

Both have XY-dimensions of about 40x40mm and Z-height of 1.3 resp. 2mm.

Please see my makes for results. Please post your makes for comparison and discussion. Thanks.

The 1st pictures shows prints with 0.025 / 0.05 / 0.1 mm layer heights for comparison.