Sourced Things and Designs Changes

This is a remix of the Universal Camera Phone/Microscope Adapter by ggoss and its remix by cfelicio. Thank you for your great designs!

It fits a 43.7 mm eyepiece (ocular), e.g. the Leica Wild M3B. The prints are different from the original Things so that less printing material is needed, bigger phones fit, and smaller screws and wing nuts can be used.

Parts needed ====================

Obligatory

• 3 * M3 x 16 mm Phillips pan head screws (DIN 7985)

• 3 * M3 hex nuts (DIN 934)

• 2 * M5 x 20 mm hex bolts (DIN 933)

• 2 * M5 wing nuts (DIN 315)

Optional (but recommended)

• 3 * 3.2 mm washers (DIN 125)
• 3 * 5.3 mm washers (DIN 125)

Assembly ====================

Phone clamps

• Add the optional 3.2 mm washers to the M3 screws.
• Insert the M3 screws through the phone clamps.
• Attach one phone clamp per rail of the main part so that the hex nuts sink into the slots on the lower side of the rails when the screws are tightened.
• The triangular projections of the phone clamps should point towards the eyepiece hole.
• Do not fully tighten the screws yet.

Microscope

• Insert the M5 hex bolts through the microscope clamp to that the bolt heads sink into the hexagonal holes.
• Push the hex bolts through the holes of the main part.
• Add the optional washers.
• Screw the M5 wing nuts on.
• Do not fully tighten the nuts yet.

Mounting ====================